Wayne-dalton-springs, wayne dalton torquemaster springs are only made for wayne dalton garage doors. garage door torsion springs and garage door extension springs are compatible with all makes and models of garage doors. you need to determine which type of garage door spring you currently have on your garage door and then replace the springs with the same type.. Find the wayne dalton garage door torquemaster springs for your garage door - easy selection of the correct replacement springs. order your springs online now., wayne dalton designed the torquemaster spring system for safety; this system allows do-it-yourselfers to install doors without all the dangers associated with standard torsion spring systems. homeowners can use a drill or a socket wrench to wind and unwind their torsion springs..
The wayne dalton torquemaster system was developed to improve on the traditional torsion spring system. the spring bar/torsion tube remains the spring bar/torsion tube remains mounted on the header above the garage door like any standard system. however, the torquemaster system hides the springs within the spring bar/torsion tube., now wayne dalton is manufacturing the torquemaster springs with a new and improved high tensile strength music wire. this allows them to make a spring slightly smaller that will install and operate the exact same as the old spring used on your application..
Hqrp drive and worm gear kit for wayne dalton 100wd 110wd 200wd 210wd 215wd 220wd 300wd 310wd 315wd garage door opener access system, these are all improvements wayne dalton has made to make your springs last longer. if you have difficulty removing your broken spring from the tube you can use a series of wodden dowel (purchased at any hardware store) and a hammer to drive out old spring parts that may be lodged in the tube..
Over the years wayne dalton has designed two types of winders to tension the springs. the original torquemaster one spring assemblies incorporate a gearbox to allow the homeowner to easily wind his springs using an electric drill with a 7/16" nut driver or socket., removal instructions for torquemaster™ single spring system a torquemaster ™ single spring system can be identified by the end brackets. the right hand end bracket will have a drive gear, counter gear, counter assembly, and a winding bolt head.. Wayne dalton garage doors and commercial doors . pair your wayne dalton door with a genie operator